Sangoma Vega 100G T1/E1 Gateway
The Sangoma Vega 100G is a 1 T1/E1 digital gateway that can be used to bridge PSTN to an IP PBX, SIP to a legacy analog PBX, or migrate from a legacy PBX to an IP PBX without installing a Sangoma T1 card into your server.
Sangoma Vega 100G T1/E1 Gateway Overview:
A Sangoma Vega 100G E1/T1 interface can be independently configured as network side or terminal side. The Vega 100G gateway can therefore be connected to a PBX or the PSTN. With this configuration there are is disruption to the configuration of existing equipment as well as flexibility and choice for call routing.
The Vega 100G gateway incorporates additional RJ45 sockets and fails over to these during outages. This resource can be utilised to achieve hardwired connection from the PBX to the PSTN for instances when the Vega is installed between the two. Or alternatively to failover to a back-up E1/T1 Vega gateway and thereby providing dual redundancy.
The Vega 100G gateway supports the following signalling schemes:
The Vega 100G supports SIP, H.323 & T.38 FAX and has proven interoperability with a wide range of existing telecommunications & VoIP equipment.
Sangoma Vega 100G Features and Functions:
- Fixed Configuration of 30 VoIP Calls
- Supports dual gigabit Ethernet connections
- Local survivability
- Available SRES and SNAP support
- Voice, FAX and Modem Support
- Flexible Call Routing for Fallback and Least Cost Routing
- Emergency PSTN Backup
- Interoperability with a Wide Range of Legacy and IP Equipment
- Digital Signaling Type
- T1, E1
- # of Digital Ports
- # of Ethernet Ports
- Ethernet Port Speeds
- 10/100/1000 Gigabit
- Protocols Supported
- Fax Support
- Echo Cancellation
- Voice Codec Support
- G.711 u/a law, G.723, G.729
- Power Supply Included
- Provisioning Options
- FTP, HTTP, HTTPS, RADIUS, TFTP
- Mounting Option
- Voice Signaling Methods
- AT&T 5ESS, DMS100, E1 CAS, ETSI/EURO ISDN, ISDN, NI1, QSIG Feature Transparency, T1 CAS, VN4, NI2
- # of VoIP Channels
- Future Scalability
Joe ShanahanDirect: 866-583-0920
Why Pay $1,157.85 for the Sangoma Vega 100G?
Fixed configuration of 30 VoIP calls
Supports dual gigabit Ethernet connections
Flexible call routing for fallback and least cost routing
For advice, reviews and industry insight... be sure to follow us online.
Questions on Sangoma Vega 100G
Q: I have an install with an older T-1 circuit pack running a robbed bit non ISDN setting, will this gateway integrate with this setup
A: T1 Vega 100G fully support T1 CAS (Robbed Bit Signalling) operation. In this mode each T1 trunk supports up to 24 simultaneous calls. The specific varieties of CAS RBS supported are:
- E&M Wink Start
- E&M Wink Start with feature group D
- FXS Loop Start
- FXS Ground Start
For more details you can review the Admin Guide that is located in the next link: ftp://ftp.sangoma.com/vega/docs/Vega_Admin_Guide_R88_v1.1.pdf