Pricing will now be shown in Canadian dollars, click the 'SHOP USA' link at the top to revert to show USD.
The Sangoma Vega 100G is a 1 T1/E1 digital gateway that can be used to bridge PSTN to an IP PBX, SIP to a legacy analog PBX, or migrate from a legacy PBX to an IP PBX without installing a Sangoma T1 card into your server.
A Sangoma Vega 100G E1/T1 interface can be independently configured as network side or terminal side. The Vega 100G gateway can therefore be connected to a PBX or the PSTN. With this configuration there are is disruption to the configuration of existing equipment as well as flexibility and choice for call routing.
The Vega 100G gateway incorporates additional RJ45 sockets and fails over to these during outages. This resource can be utilised to achieve hardwired connection from the PBX to the PSTN for instances when the Vega is installed between the two. Or alternatively to failover to a back-up E1/T1 Vega gateway and thereby providing dual redundancy.
The Vega 100G gateway supports the following signalling schemes:
The Vega 100G supports SIP, H.323 & T.38 FAX and has proven interoperability with a wide range of existing telecommunications & VoIP equipment.
Q: I have an install with an older T-1 circuit pack running a robbed bit non ISDN setting, will this gateway integrate with this setup
A: T1 Vega 100G fully support T1 CAS (Robbed Bit Signalling) operation. In this mode each T1 trunk supports up to 24 simultaneous calls. The specific varieties of CAS RBS supported are:
- E&M Wink Start
- E&M Wink Start with feature group D
- FXS Loop Start
- FXS Ground Start
For more details you can review the Admin Guide that is located in the next link: ftp://ftp.sangoma.com/vega/docs/Vega_Admin_Guide_R88_v1.1.pdf