With the introduction of Polycom’s 3.0.0 SIP firmware, users using cordless DECT or Bluetooth headsets now have the ability to answer and end calls from their Polycom phones with an easy press of a button on the headset itself. No need for a Handset Lifter or corded solution! This is a very nice and useful feature since in the past…and I know…. handset lifters tend to take the handset completely off the Polycom phone, thus requiring a special part from both GN Netcom Jabra and Plantronics. Forget about all of that and make the shift …utilize the Electronic Hookswitch feature at its best.
There are a couple things you should know first before you go and experiment with your Polycom phones. The Electronic Hookswitch feature or EHS works through the Polycom IP Phones serial port connection located on the back-side of each of these models: IP-320/330, 430, 550, 560, and 650 and pictured below:
The connection then feeds into the AUX port of these two (compatible) headsets from GN Netcom Jabra (GN9350 and GN9120 with EHS adapter). Please refer to picture below:
There are a couple changes that need to be made to Polycom phone configuration as well. This is described in Polycom’s Technical Bulletin 35150, but in short, you must perform the following:
Edit the up.analogHeadsetOption to “1”in the sip.cfg file. This value is set to “0” by default and when set to “1” allows DHSG-compatible headsets to be attached to the Polycom phone.
From the Phone UI, access the Menu, Settings, Basic, Preferences, Headset, and Analog Headset and then select Jabra Mode
Ensure that the physical connection as noted in the above illustration is correct!!
I would also like to inform you a few other special requirements that may be needed under certain applications and variations of the Polycom and GN Netcom Jabra products.
When using a Polycom IP-320/330, you will need a GN Netcom Jabra 2.5mm to RJ-9 adapter cord since the Polycom IP-320/330 have a 2.5mm headset jack.
When using the GN9350 headset, the unit does NOT ship with the EHS connection cable described in the above illustration (From Polycom Phone serial port to AUX port on GN9350/9120).This is a required accessory product of the GN9350/9120.
You must be running Polycom 3.0.0 SIP Firmware or higher and bootrom 4.1.0.
You want to optimize your meeting space or conference room to ensure every remote or…
https://youtu.be/58HX8VIljrY?si=v4-BBtOhIiDujgch In the fast-paced world of Telecommunications, things can happen, and sometimes those things require…
In an office setting, there will most likely be a professional business phone on your…
https://youtu.be/WsVpLUdxYuQ?si=g7Arw3u20MWfKq8q We're back with more VoIP News for April 2025! In this month's episode, we'll…
Growing pains don’t only happen to people, they happen to businesses too! It’s fantastic that…
When looking into new or upgraded IP paging equipment, many people don’t realize that you…
View Comments
The Polycom IP501 units also have the 6-pin serial port. Should they work, or must they be upgraded to one of the other listed units? Thanks.